User Manual

Reference Manual
Appendix
156
Basic Structure
Functional Blocks
Tone Generator
A/D Input
Arpeggio
Sequencer
Audio Record/Play
Controller
Effect
Internal Memory
Reference
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Appendix
About MIDI
Display Messages
Troubleshooting
Playback continues without stopping
 When the [ARP ON/OFF] button is turned on, press it so that its lamp is turned off.
 In Sequence Play Mode, press the [START/STOP] button.
 When the click (metronome) sound continues, hold down the [SHIFT] button and press
the [START/STOP] button to stop the sound.
The sound is distorted
 Are the effect settings appropriate?
Use of an effect at certain settings may produce distortion.
[VOICE]  [EDIT]  Effect (page 44)
[PERFORM]  [EDIT]  Common  Effect (page 77)
[MULTI/SEQ PLAY] (selecting Multi mode)  [EDIT]  Common  Effect (page 96)
Use of the Master Effect at certain settings may produce distortion.
[UTILITY]  Voice  Master FX (page 142)
[PERFORM]  [EDIT]  Common  Effect  Master (page 77)
[MULTI/SEQ PLAY] (selecting Multi mode)  [EDIT]  Common  Effect  Master (page 96)
 Are the filter settings appropriate?
Excessively high filter resonance settings can cause distortion.
[VOICE]  [EDIT]  Filter/EG (page 43)
[PERFORM]  [EDIT]  Common  Filter/EG (page 75)
[PERFORM]  [EDIT]  Part selection  Filter/EG (page 88)
[MULTI/SEQ PLAY] (selecting Multi mode)  [EDIT]  Part selection  Filter/EG (page 108)
 Are any of the following volume parameters set so high that clipping is occurring?
[UTILITY]  General  Volume (page 133)
[UTILITY]  General  L&R Gain (page 133)
[VOICE]  [EDIT]  Play Mode  Volume (page 34)
[PERFORM]  [EDIT]  Common  Play Mode  Volume (page 73)
[PERFORM]  [EDIT]  Part selection  Play Mode  Volume (page 82)
[MULTI/SEQ PLAY] (selecting Multi mode)  [EDIT]  Part selection  Play Mode  Volume (page 102)
Sound is cut off
 Is the entire sound (via your keyboard playback and Sequence playback) exceeding the
maximum polyphony of the synthesizer? (page 7)
Only one note sounds at a time
 When this situation occurs, the Mono/Poly parameter in the current mode is set to
“mono.”
If you wish to play chords, set this parameter to “poly.”
[VOICE]  [EDIT]  Play Mode  Mono/Poly (page 35)
[PERFORM]  [EDIT]  Part selection  Play Mode  Mono/Poly (page 82)
[MULTI/SEQ PLAY] (selecting Multi mode)  [EDIT]  Part selection  Play Mode  Mono/Poly (page 102)