User Manual

Reference Manual
Reference
30
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Voice
Play
Normal Voice Edit
Common Edit
Name
Play Mode
Arpeggio
Arp Edit
Arp 1-5 Type
Controller
LFO
Filter/EG
3 Band EQ
Effect
Element Edit
OSC
Tune
PEG
Filter Type
FEG
Filter Scale
AMP Level/Pan
AEG
AMP Scale
LFO
EQ
Drum Voice Edit
Common Edit
Name
Play Mode
Arpeggio
Controller
Filter/EG
3 Band EQ
Effect
Key Edit
OSC
Tune
Filter Type
AMP Level/Pan
AEG
EQ
Job
Recall
Bulk
Supplementary Info.
Basic Structure
Appendix
Four functions can be assigned to each Slider, alternatively selected via the Slider Function button. Each time the button
is pressed, the lamp lights alternatively in descending order, VOLUME | PAN | CHO SEND | REV SEND.
The Slider 1 is only available in the Voice mode. The four sliders let you adjust the parameters of the Play Mode display
in the Voice Edit mode.
NOTE:
When all the lamps are turned off by pressing the Slider Function button a few times in the Voice Edit mode, you can adjust
Element levels 1 – 4 by using the Sliders 1 – 4.
The Edit (E) indicator
When changing the value of the parameter in the Voice Play or Edit mode, the Edit (E) Indicator will appear on the top
right corner of the LCD display. This gives a quick confirmation that the current Voice has been modified but not yet
stored. To store the current edited status, press the [STORE] button to store the edited Voice.
Storing the created Voice
1 Press the [STORE] button to call up the Voice Store display.
2 Set the destination for storing the Voice.
Select a Voice Bank and Number as destination by using the Data Dial, [DEC] and [INC] buttons. You can use the
[A] – [H] buttons and [1] – [16] buttons to select a Voice number.
NOTE
When this display is shown, you can hear the original sound at the destination by pressing the [EDIT] button to call up the
Compare mode. Pressing the [EDIT] button again will exit from the Compare mode.
3 Press the [ENTER] button. (The display prompts you for confirmation.)
To cancel the Store operation, press the [EXIT] button.
4 Press the [ENTER] button to execute the Store operation.
After the Voice has been stored, a “Completed” message appears and operation returns to the Voice Play display.
CAUTION
When you execute the Store operation, the settings for the destination memory will be overwritten. Important data should always
be saved to the internal flash memory or a USB storage device connected to the USB TO DEVICE terminal. For detailed
instructions on saving, see page 127.
Function assigned to Sliders
VOLUME Adjusts the level of the Voice
PAN Adjusts the stereo pan position of the current Voice.
CHO SEND (Chorus Send) Adjusts the Chorus Send Level
REV SEND (Reverb Send) Adjusts the Reverb Send Level
Slider Function button
Current value Function of currently operated Slider
Unedited value (previously saved)