User Manual

Reference Manual
Reference
87
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Performance
Play
Mixing
Edit Select
Common Edit
Name
Play Mode
Arpeggio
Controller
Filter / EG
EQ
Effect
Parameter
A/D Out
A/D FX
Parameter
Part Edit
Voice
Play Mode
Arpeggio
Arp Edit
Arp 1-5 Type
Filter / EG
3 Band EQ
Rcv Sw
FX Send
Job Select
Recall
Bulk
Copy
Initialize
Supplementary Info.
Basic Structure
Appendix
Accnt Strt Qtz (Accent Start Quantize)
Determines the start timing of the Accent Phrase when the Velocity specified in Accent Velocity Threshold above is
received. When set to off, the Accent Phrase starts as soon as the Velocity is received. When set to on, the Accent
Phrase starts on the beat specified for each Arpeggio type after the Velocity is received.
Settings: off, on
Random SFX
Some Arpeggio types feature a Random SFX function which will trigger special sounds (such as guitar fret noises) when
Note Off messages are received. This parameter determines whether the Random SFX is active or not.
Settings: off, on
SFX Vel Offset (Random SFX Velocity Offset)
Determines the offset value by which the Random SFX notes will be shifted from their original velocities. If the resultant
Velocity value is less than 1 it will be set to 1, and if the resultant Velocity value is greater than 127 it will be set to 127.
Settings: -64 – +0 – +63
SFX Key on Ctrl (Random SFX Key On Control)
When this is set to “off,” the Random SFX special sound is played with the pre-programmed velocity. When this is set to
“on,” the Random SFX special sound is played with the velocity generated when the note is pressed.
Settings: off, on
Determines the settings of the Arpeggio selected on the “Arp Select”.
Main Ctgry (Main Category)
Sub Ctgry (Sub Category)
Determines the Arpeggio Main Category and Sub Category including the desired Arpeggio type.
Settings: Refer to the Arpeggio Category List on page 7.
Type (Arpeggio Type)
Determines the desired Arpeggio Type number from the specified Category. The number and name of the selected
Arpeggio Type is shown at the second line on the display. Refer to the Arpeggio Type List in Data List (separate PDF
documentation).
NOTE:
For details about how to use the Arpeggio Type List in Data List (separate PDF documentation), see page 9.
Vel Rate (Velocity Rate Offset)
Determines the offset value by which the Arpeggio notes will be shifted from their original velocities. If the resultant
Velocity value is less than 1 it will be set to 1, and if the resultant Velocity value is greater than 127 it will be set to 127.
Settings: -100% – +0% – +100%
GTime Rate (Gate Time Rate Offset)
Determines the Gate Time (length) of the Arpeggio notes. The Gate Time cannot be decreased beyond its normal
minimum of 1; any values outside that range will automatically be limited to the minimum.
Settings: -100% – +0% – +100%
Arp 1 – 5 Type (Arpeggio 1 – 5 Type)