User Manual

Starting the S90 XS/S70 XS Editor VST
S90 XS/S70 XS Editor VST Owner’s Manual
5
4. Click the Output Setup button at the right side of the Edit button ( ) in the VST
Instrument Rack, then verify that “S90/S70 XS 1 [stereo] is selected. If you want to use
the ASSIGNABLE OUTPUT L/R jacks for Cubase project, also check (enable) “S90/S70
XS 2 [stereo].”
After this operation, the S90 XS/S70 XS Busses appear in the project window of the DAW application.
5. Call up the Editor Setup window in the S90 XS/S70 XS Editor VST via [File] ➞ [Editor
Setup].
6. Set the “Detail” column to “off” at the USB in the Data Port section.
7. Select “S90 XS/S70 XS” at the [USB Device] column.
8. Click [OK] button at the bottom.
9. Call up the VSTi Setup window in the S90 XS/S70 XS Editor VST via [File] ➞ [VSTi
Setup].
10. Set signal input ports of your audio interface that is connected with the S90 XS/S70 XS
in the Audio Return Ports column.
11. Click the [OK] button at the bottom.
12. If the S90 XS/S70 XS Editor VST is “OFFLINE,” click the [ONLINE/OFFLINE] button to go
“ONLINE.”