User Manual

Assembly Guide

Setup

DTX402K DTX432K DTX452K Owner’s Manual

Rotating the pads into place

Step 5 applies to each of the four pads.

Step 5 applies to each of the three tom pads. For adjusting the snare pad, see .

1. Loosen the  key bolt on each of the pads.

2. Rotate the pads to positions where they will be easy to play. (If necessary, refer to the picture of the properly assembled kit

on page 12.)

3. Tighten each of the key bolts to secure the pads in place.

Attaching the hi-hat holder

1. Loosen the two  key bolts in the back of the snare part.

2. Insert the hi-hat holder into the back of the snare part as shown in the figure.

• When correctly inserted, the tip of the hi-hat holder will protrude slightly from the bottom of the snare part.

• When correctly oriented, the hi-hat holder will be horizontal to the snare part as shown in the Top view.

3. Tighten the two  key bolts to secure the hi-hat holder.

For DTX402K and DTX432K

For DTX452K

For the snare pad, you can also adjust the angle of the joint which supports the snare pad by loosening the s key bolt.

The hi-hat holder and the other two cymbal holders seem similar, but are actually different.

Only the hi-hat holder has a washer and stopper.

Step 5

Step 4

Snare pad

NOTE

Step 6

Hi-hat holder

Stopper

Top view

Washer