User Manual

Assembly Guide

Setup

DTX402K DTX432K DTX452K Owner’s Manual

Connecting the pads to the drum module

1. Insert the mini plugs* at one end of the nine-channel snake cable into the correct trigger input jacks (SNARE to KICK/

PAD) on the drum module. (*: The smaller set of plugs.)

2. Insert the nine-channel snake cable’s standard plugs* into the jacks in the corresponding pads. (*: The larger set of plugs.)

3. Wrap the cables for the snare pads, the tom pads, and the cymbal/hi-hat pads around the cord clip to prevent them from

being pulled out.

4. Using the cable bands, secure the cables to the kit rack at the positions in the figure above.

Congratulations—You have finished assembling your electronic drum kit!

Setup for Left-handed Drummers

Assemble the drum kit referring to the illustration.

Two of the joints should be placed differently from this setup for right-

handed drummers.

The sticker on each of the snake cable’s plugs indicates the name of the corresponding pad.

For the kick pad KP65 in the DTX432K and DTX452K, use the OUT>DTX jack. No sound will be played when the PAD>IN jack is

used.

Excessive bending can damage the cables. Ensure, therefore, that they are not bent at an extreme angle when wrapped around the

cord clip.

Step 14

RIDE

SNR

KICK

HHC

TOM3

TOM2 TOM1

KICK

HHC

RIDESNRHH

KICKHHCHHCRRIDETOM3TOM2TOM1SNR

TOM2TOM1CR TOM3 KICK HHC

DTX402K

Trigger input jacks on the drum module

Nine-channel snake cable

NOTE

NOTICE

Fully assembled drum kit (DTX452K shown)

Right-handed Left-handed