User Manual

Setting Parameters using Menu Mode
52
Advanced Techniques
DTX402K DTX432K DTX452K Owner’s Manual
4. Select the setting for each drum pad using the number
buttons [1] to [5]. When set to producing a sound, the
pad will produce a sound whenever they are struck.
When set not to producing a sound, only pads played
exactly in time will produce a sound.
6-4. Rhythm Gate Indicator Flipped
For Rhythm Gate (page 32), the time indicator using the
number buttons can be reversed, according to your prefer-
ence. In the normal mode, “fast” is on the left. In the reverse
mode, “fast” is on the right.
1. Hold down the Mode switch to activate Menu Mode.
2. Press the number button [6] to select the Training Set-
tings.
3. Press the number button [4] to select Rhythm Gate
Indicator Flipped.
4. Select the mode using the number button [1] or [2].
6-5. Dynamic Gate Low Limit
For Dynamic Gate (page 33), you can set the low limit (the
threshold value between “Weak” and “Normal”).
1. Hold down the Mode switch to activate Menu Mode.
2. Press the number button [6] to select the Training Set-
tings.
3. Press the number button [5] to select Dynamic Gate
Low Limit.
4. Set the threshold value using the TEMPO[+]/[–] but-
tons.
6-6. Dynamic Gate High Limit
For Dynamic Gate (page 33), you can set the high limit (the
threshold value between “Normal” and “Strong”).
1. Hold down the Mode switch to activate Menu Mode.
2. Press the number button [6] to select the Training Set-
tings.
3. Press the number button [6] to select Dynamic Gate
High Limit.
4. Set the threshold value using the TEMPO[+]/[–] but-
tons.
Number button Settings
[1] Hi-Hat
[2] Snare
[3] Kick
[4] Tom
[5] Cymbal
Steps:
Hold down the Mode switch  [6]  [4]  Setting
Number
button
Settings Description
[1]
Normal
mode
[2]
Reverse
mode
Produce a sound (fully lit)
Not producing a sound (half lit)
Setting
1 2 3 4 5 6 7 8 9 10
Fast Slow
1 2 3 4 5 6 7 8 9 10
Slow Fast
Steps:
Hold down the Mode switch  [6]  [5]  Setting
Setting
2 to 99
This setting may be automatically fixed so as not to exceed the
setting value of Dynamic Gate High Limit.
Steps:
Hold down the Mode switch  [6]  [6]  Setting
Setting
2 to 99
This setting may be automatically fixed so as not to be below the
setting value of Dynamic Gate Low Limit.
Setting
NOTE
Setting
NOTE