User Manual
Table Of Contents
- Cover
- PRECAUTIONS
- Introduction
- Contents
- Main Features
- Structure of Manuals
- Included Accessories
- Functions
- HOME Screen
- Main Menus and Examples of Screens
- Screen Operations
- Using a USB Flash Drive to Save/Load Data
- Basic Settings
- Dante Connection
- Cardioid Mode Settings
- Rotatable Horn
- Installation Examples
- Optional Accessories (sold separately)
- Troubleshooting
- General Specifications (English only)
- Dimensions (English only)
16
Rotatable Horn
When shipped from the factory, the directivity of DZR(-D) series speaker in a vertical orientation is the setting which
makes the sound expand in a horizontal direction, and inhibits or narrows the sound in a vertical direction. We rec-
ommend changing the directivity by rotating the horn when you want to install the DZR(-D) series speaker horizon-
tally or when you want to use them as a floor monitor and broaden the directivity.
1. Using a 2.5 mm hexagonal wrench, remove all fixing screws (DZR10(-D): six total) on the grille, and remove the grille from
the speaker.
2. Using a No. 2 Phillips head screwdriver, remove all screws installed on the horn and pull the horn out from the speaker.
3. Rotate the horn 90 degrees, and re-install the horn to the speaker, reversing the steps above.
• Make sure not to push the screws too strongly with the Phillips head screwdriver. This may cause the nuts inside the cabinet to fall off.
• If the horn cannot smoothly be pulled out, hook the notches using a flat-bladed screwdriver, and pull out.
Full range: DZR15(-D), DZR12(-D), and DZR10(-D)
NOTE
Screws (eight total)
Notch
Vertical
Rotate 90°
Horizontal