User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
46
• Output configuration settings (Speaker Property - Config)
Y-S
3
automatically generates the output system configuration to suit each speaker array type and displays them in
the Config view in Speaker Property. You may adjust the input signal level, source type, delay, EQ, speaker processor
and amp model. To reflect the settings in calculation results, click . For details, see “Output Configuration
Settings (Speaker Property - Config)” in the “5-1. Speaker Arrays” section.
Installation plane configuration Configuration of individual speakers installed on a plane
Amplifier - Speaker Combination
Click to open the Amplifier - Speaker Combination window. You can use the list boxes to select and
change amplifier type and gain, mode settings, connection method, and speakers. You can also select the amplifier
number of a selected speaker to combine it with a particular amplifier. To prevent erroneous connections, when you
press , Y-S3 checks that speakers and amplifiers are connected appropriately. If Y-S
3
deems a configuration
incorrect, it displays a warning dialog.
Chapter 5 closing material: Speaker Config