User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Update procedure sequence
- ■ Checking the version number
- ■ Preparing for the update
- ■ Updating the RMio64-D firmware
- ■ Installing the Dante Firmware Update Manager
- ■ Computer TCP/IP setting
- ■ Updating the Dante firmware
- ■ About Failsafe Mode
- ■ Error Message List (RMio64-D Update Program)
7
■
Computer TCP/IP setting
To update Dante firmware, configure computer TCP/IP settings.
After the firmware update procedure is complete, return the TCP/IP settings to their
original settings.
Windows
1.
Open the Network and Sharing Center as described below.
Windows 7
Select [Start] [Control Panel], then click or double-click [Network and Sharing
Center] or [View network status and tasks].
Windows 8, Windows 8.1 or Windows 10
[Windows]+[X] [Control Panel], then click or double-click [Network and Sharing
Center] or [View network status and tasks].
2.
Click [Manage network connection] or [Change Adapter settings] from the “Tasks”
list located in the left side of “Network and Sharing Center” window, then double-
click [Local Area Connection].
The "Local Area Connection Status" dialog box will be displayed.
• The “User Account Control” dialog box may appear. Click [Continue] or [Yes].
• If the “Local Area Connection properties” dialog box appears, skip ahead to step
4.
3.
Click [Properties].
The "Local Area Connection properties" dialog box will be displayed.
The “User Account Control” dialog box may appear. Click [Continue] or [Yes].
4.
Select [Internet Protocol Version 4 (TCP/IPv4)], then click [Properties].
The “Internet Protocol Version 4(TCP/IPv4) Properties” dialog box will be
displayed.