User Manual

Assembly Guide

Setup

DTX402K DTX432K DTX452K Owner’s Manual

Attaching the hi-hat pad

 Adjusting the position of the hi-hat stopper

1. Loosen the  key bolt on the stopper, which is located at the top of the hi-hat holder.

2. Adjust the position of the stopper until it is straight in the back (as shown in the illustration) from your playing position.

3. Tighten the  key bolt to secure the stopper.

 Assembling the hi-hat pad

1. Remove the wing nut, the washer, and the upper felt pad from

the hi-hat holder. (Do not remove the lower felt pad.)

2. Place the hi-hat pad, which does NOT have a sticker labeled

“CRASH,” on the hi-hat holder with the stopper also passing

through the hole provided.

3. Replace the felt pad removed in Step 1 above the hi-hat pad.

4. Replace the washer removed in Step 1 above the felt pad.

5. Tighten the wing nut to secure the hi-hat pad in place.

Attaching the drum module

1. Loosen the  key bolt on the back left of the rack and turn the joint around before sliding the sliding the drum module (in

the next step).

2. Loosen the s key bolt and slide the drum module fully back into the joint in Step 1.

3. Tighten the  and s key bolts to secure the drum module in place.

Step 7

Playing position

Stopper

Wing nut

Felt pad

Hi-hat pad

Hi-hat holder

Stopper

Washer

Felt pad

Step 8