User Manual

Assembly Guide
17
Setup
DTX402K DTX432K DTX452K Owner’s Manual
Attaching the cymbal holders
1. Loosen the four  key bolts at the ends of the tom 1/2 part.
2. Insert the cymbal holders into the ends of the top 1/2 part. Then adjust the angles of the cymbal holders until they are ori-
ented as shown in the figure.
• When correctly inserted, the tips of the cymbal holders will protrude slightly from the bottom of the tom part.
• When correctly oriented, the cymbal holders will bend in the back from your playing position.
3. Tighten the four  key bolts to secure the cymbal holders in place.
Assembling the cymbal pads
1. Remove the wing nut and the upper felt pad from the cymbal holder. (Do
not remove the lower felt pad.)
2. Place the cymbal pad on the cymbal holder, with the holder passing
through the central hole.
3. Replace the felt pad removed in Step 1 above the cymbal pad.
4. Tighten the wing nut to secure the cymbal pad in place.
The two cymbal holders are identical.
The crash cymbal, which has the sticker labeled “CRASH” on the rear side and has some bumps on the front side, is
for the left.
The normal cymbal, which is identical with the hi-hat cymbal, is for the right.
Step 9
Playing position
NOTE
Step 10
Sensor (bumps)
Wing nut
Felt pad
Felt pad
Cymbal holder
Cymbal pad