User Manual

Setting Parameters using Menu Mode
49
Advanced Techniques
DTX402K DTX432K DTX452K Owner’s Manual
5-2. Crosstalk
The term “crosstalk” refers to the output of spurious trigger
signals from a pad other than the one that was stuck as a
result of vibration or interference between pads. You can
adjust the Crosstalk parameter for individual pads to prevent
this phenomenon from occurring.
1. Hold down the Mode switch to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [2] to select the Crosstalk param-
eter.
4. Strike a pad to select it.
5. Enter a new setting (%) using the TEMPO[+]/[–] but-
tons. Larger values are more effective in preventing
crosstalk; however, they can also make it difficult to
play pads simultaneously during light drumming.
5-3. Snare Pad Type
You can specify the type of snare pad connected to your
drum module.
1. Hold down the Mode switch to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [3] to select the Snare Pad Type
parameter.
4. Select a new snare pad type using the corresponding
number button [1] to [6].
Steps:
Hold down the Mode switch  [5]  [2]  Setting
Setting
0 to 99
Setting
Steps:
Hold down the Mode switch  [5]  [3]  Setting
Number button Setting
[1]
Automatic identification
(only for [2] and [3])
[2] TP70S
[3]
Snare pad that comes with DX402K/
DTX432K
[4] XP-series pad
[5] TP70S reversed
[6] XP-series pad reversed
• When set to [1], the drum module will automatically identify the
type of snare pad that came with your electronic drum kit when it
is turned on. If you then press and hold number button [1], the
drum module will flash number button [2] or [3] to indicate the
result of automatic identification.
• Whenever you change the type of snare connected to the drum
module, please update this setting using the corresponding
number button [2] to [4]. For example, when you use the XP-
series pad, select [4].
• You can use setting [5] or [6] to switch (or reverse) the drum
sounds assigned to Rim 1 and Rim 2. This makes it easier for
left-handed drummers to configure their electronic drum kit.
Setting
NOTE