User Manual

Setting Parameters using Menu Mode
50
Advanced Techniques
DTX402K DTX432K DTX452K Owner’s Manual
5-4. Pedal Type
Use the following parameter to specify the types of pedals
(i.e., hi-hat controller and kick) connected to your drum
module.
1. Hold down the Mode switch to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [4] to select the Pedal Types
parameter.
4. Select a new pedal type combination using the corre-
sponding number button [1] to [5].
5-5. Gain
You can set the gain level for trigger signals output from
individual pads. The higher the gain setting, the louder the
sounds produced by light drumming.
1. Hold down the Mode switch to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [5] to select the Gain parameter.
4. Strike a pad to select it.
5. Enter a new gain level using the TEMPO[+]/[–] but-
tons.
5-6. Minimum Level
When the strength with which you strike a pad is no more
than this level, the pad will not output a trigger signal in
response and no sound will be produced.
1. Hold down the Mode switch to activate Menu Mode.
2. Press number button [5] to select the Trigger Settings
parameter group.
3. Press number button [6] to select the Minimum Level
parameter.
4. Strike a pad to select it.
5. Enter a new setting (%) using the TEMPO[+]/[–] but-
tons.
Steps:
Hold down the Mode switch  [5]  [4]  Setting
Number
button
Setting
Hi-hat controller Kick pedal
[1] Automatic identification (only for [2] and [3])
[2] HH65 KP65
[3] HH40 KU100
[4] HH40 KP65
[5] HH65 KU100
• This parameter can normally be set to [1] (automatic identifica-
tion).
• When set to [1], the drum module will automatically identify the
type of pedal that came with your electronic drum kit when it is
turned on.
If you then press and hold number button [1], the drum module
will flash number button [2] or [3] to indicate the result of auto-
matic identification.
• Connect the hi-hat controller before turning on the drum module.
Please do not turn the drum module on with the hi-hat controller
depressed. The drum module can not identify the type of pedal
properly and it causes that the kick may produce much smaller
sound than expected.
• Whenever you change the type of hi-hat controller or kick pedal
connected to the drum module, please update this setting using
the corresponding number button [2] to [5].
Setting
NOTE
Steps:
Hold down the Mode switch  [5]  [5]  Setting
Setting
1 to 127
Steps:
Hold down the Mode switch  [5]  [6]  Setting
Setting
0 to 99 (%)
Setting
Setting