User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-29-
Click Ok to proceed or Cancel to abort the lock process.
While the residual connections are being closed, Dante Controller displays a progress dialog:
When the preparation process is finished, the standard Lock Device dialog is presented, and the device
can be locked as normal.
Dante Control and Monitoring
In addition to automatic configuration and discovery, audio transport and routing, Dante-enabled devices
can also be controlled and monitored in various ways. This includes being able to view and change specific
parameters, such as clock configuration settings. Dante devices are also capable of sending status events
that can be viewed using Dante Controller. Status events include changes in clock status, or network
interface changes.
Note: The computer service that manages control and monitoring is called 'ConMon' or 'Dante
Control and Monitoring'.