User Manual
Table Of Contents
- Getting Started
- Main window
- Overview window
- Selected Channel window
- Library window
- Premium Rack Library window
- Patch Editor window
- Virtual Rack window
- Meter window
- Group/Link window
- Scene window
- Custom Fader Bank Setup window
- Custom Fader Bank window
- User Defined Keys Setup window
- User Defined Knobs Setup window
- Sends On Fader window
- Outport Setup window
- Keyboard Shortcuts
- Index
CL Editor Owner’s Manual
44
5 HA (HA analog gain)
Adjusts the analog gain for OMNI IN. This knob appears only if OMNI IN is patched to a head amp.
6 48V (Phantom power)
Switches phantom power (+48V) on/off. This button appears only if the channel is patched to a head amp.
The number of available insert-ins/outs is limited. (➥ p.60, p.61)
If you assign more insert-ins/outs than the limitation, invalid insert-ins/outs will be grayed out. Also, the
indicator will appear.
❏ DIRECT OUT (except for ST IN channels)
1 ON
Turns the direct output on/off. You can right-click (<control> key + click) the button to display a popup menu and
select ALL ON or ALL OFF.
2 DIRECT OUT GAIN
Adjusts the gain of the direct output. The current value is shown in the numerical box below the knob. You can set this
to the nominal value (0.0 dB) by holding down the <Ctrl>(< >) key and clicking the knob.
3 DIRECT OUT PORT
Click this to select one of the following output ports as the one used for direct out.
4 DIRECT OUT POINT
Selects the position at which direct out will be patched. Choose from PRE HPF, PRE EQ, PRE FADER, or POST ON.
❏ RECALL SAFE/MUTE SAFE
These enable/disable Recall Safe and Mute Safe for the channel.
NONE No assignment
DANTE 1–DANTE 64 DANTE OUTPUT 1–64
OMNI 1–OMNI 8 OMNI OUT jacks 1–8
REC L, REC R L/R inputs of RECORDER
SLOT1-1, SLOT1-2...SLOT3-16 Output channels of an I/O card installed in slots 1–3
NOTE
1
23 4