User Manual

8. "Tuning" sheet

The "Tuning" sheet supports only the PC series and XMV series units.
Power amp channels that are grouped across devices of the same series are called a "link group." By using the
link group editor, grouped channels can be operated in tandem, as either relative values or absolute values of the
same type of parameter.
To create a link group, you can drag and drop a [Group] from the "Components" area of the "Tuning" sheet.
In the "Components" area, you can double-click [Group] to enter Stamp mode. A [Group] is placed each time you
click the sheet. To exit Stamp mode, press < Esc >.
Registration to a link group can be done in the following ways.
Registration source Registration method
"Project" sheet Right-click a device, and use [Add to Link Group] to select the channel and link
group that will be registered.
After selecting multiple devices, right-click a device and use [Add to Link Group] to
select the channel and link group that will be registered.
"Tuning" sheet In the "Project Devices" area, drag and drop a channel from "Amplifiers" or
"Speakers" into [Group].
In the "Project Devices" area, right-click a channel of "Amplifiers" or "Speakers" and
use [Add to Link Group] to select the link group to which it will be registered.
When you double-click an object in the "Tuning" sheet, the link group component editor opens.
For details on the link group component editor, refer to the component editor of each device.
8. "Tuning" sheet
ProVisionaire Design User Guide | 47