User Manual

Example Program for Crestron - Setup Guide -

Step by step setup

1. Assemble the hardware and connect up both the Crestron & Yamaha components

together as shown in the system diagram.

2. Verify all devices have power.

3. Verify all devices are upgraded to the firmware versions mentioned above.

4. Verify there is network activity by looking at the link/activity lights on the network switch.

5. For mixers, configure the MIDI settings as shown in the screenshots below.

To save time, we have also prepared Studio Manager files which contain scenes and

MIDI configuration settings.

6. For all devices, store scenes or load pre-prepared scenes.

15 are available on the touch panel for the M7CL

15 are available on the touch panel for the 01V96

5 are available on the touch panel for the LS9

8 are available on the touch panel for the DME24N/DME64N/DME4io-C

16 are available on the touch panel for the IMX644, but only 4 memories are

necessary as the front panel has 4 memories.

(Note that if you select a scene button on the touch panel and there is no scene on the

device nothing will happen, which is not very exciting!)

7. Configure IP addresses of the DME4io-C.

8. For DME models, synchronise the provided DME Designer files using DME Designer.

9. Extract Crestron files which are zipped in:

- YamahaCA_Crestron_ExampleV1.0_Programming.zip

- YamahaCA_Crestron_ExampleV1.0_TP.zip

- YamahaCA_Crestron_ExampleV1.0_DynamicContentsRev1.2.zip

Then, compile and transfer.

10. Configure the setup pages of the Crestron system as detailed below.

11. Setup completed.

Steps which need further explanation have more information below.