User Manual

Console Setup
1. Open the MIDI SETUP page on Console #1 (using the [MIDI]
DISPLAY ACCESS key) and turn on Tx and Rx for both
PROGRAM CHANGE and PARAMETER CHANGE. Also make
sure the Tx and Rx CHANNEL number is the same (see
diagram below).
2. Make sure the MIDI Program Assign Table (on the PGM ASGN
page) contains the default settings. If it doesn’t, then
INITIALIZE it, so PGM 1 recalls Scene 1, PGM 2 recalls Scene
2 and so on…
3. Open the MIDI/HOST page on Console #1 (found in the
[SETUP] menu) and set the GENERAL Rx PORT and Tx PORT
to MIDI (as shown below).
3 YAMAHA Digital Mixers: A Redundancy Guide