User Manual

Example Program for AMX - Setup Guide -
2
Tested Firmware Versions
NI-700 processor : v3.41.414
NXT-1200VG touch panel : v2.60.25
The program has been tested using the above firmware combination. Different firmware
combination could cause unexpected behaviour. Please refer to the AMX website to
check firmware update history.
File list
Please download and unzip all of these files:
YamahaCA_AMX_ExampleV1.0_Programming.zip
NetLinx Studio files for compiling and uploading to the processor. Written for AMX NI-700
YamahaCA_AMX_ExampleV1.0_TP.zip
TPDesign4 files for uploading to the touch panel. Written for NXT-1200VG
YamahaCA_AMX_ExampleV1.0_DynamicContentRev1.2.zip
Language and image files. FTP to the processor and upload.
YamahaCA_AMX_ExampleV1.0_YamahaDevices.zip
Studio manager files for mixers, and configuration files for DME processors and IMX644
installation mixer
YamahaCA_AMX_ExampleV1.0_SetupGuide.pdf
This Setup Guide
Protocol Specification documents
Each Yamaha device protocol specification document is available as below.
DME24N/64N/DME4io-C : Protocol document on Yamaha web site
01V96, M7CL, LS9 : Protocol document on Yamaha web site
IMX644 : Described in owner’s manual
BD-S2900 : Please contact your nearest Yamaha branch
Assigned IP address
IP addresses for all the system components.
192.168.0.101 DME24N
192.168.0.102 DME64N
192.168.0.103 DME4io-C
192.168.0.201 AMX NI-700
192.168.0.202 AMX NXT-1200VG touch panel
The device configuration page on the touch panel has pre-configured IP addresses for
Yamaha devices. You need to set these identical IP addresses in to the connected
Yamaha devices. If you require different IP addresses, these must be modified in the AMX
source code before compiling.