User Manual

General Specifications
0 dBu = 0.775 Vrms Output impedance of signal generator (Rs) = 150 Ω
All level knobs are nominal if not specified.
Frequency Response Input to STEREO OUT
+0.5 dB/-0.5 dB (20 Hz to 20 kHz),
refer to the nominal output level @ 1 kHz, GAIN knob: Min
Total Harmonic Distortion
(THD+N)
Input to STEREO OUT
0.01 % @ +8 dBu (20 Hz to 20 kHz), GAIN knob: Min
0.003 % @ +18 dBu (1 kHz), GAIN knob: Min
Hum&Noise *1
(20 Hz to 20 kHz)
Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150Ω, GAIN knob: Max)
Residual Output Noise -102 dBu (STEREO OUT, STEREO LEVEL knob: Min)
Crosstalk (1 kHz) *2 -88 dB
Input Channels 6 channels: Mono (MIC/LINE): 2, Stereo (LINE): 2
Ouput Channels STEREO OUT: 2, PHONES: 1
Bus STEREO: 1
Mono Input Channel Function
PAD 26 dB
HPF 80 Hz, 12 dB/oct
EQ HIGH Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
EQ LOW Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
PEAK LED
LED turns on when post EQ signal reaches 3 dB below clipping
(+11 dBu)
Level Meter
Post STEREO LEVEL
Knob
2 x 7-segment LED meter [PEAK (+11), +6, +3, 0, -3, -10, -20 dB]
Internal Digital Effect (MG06X) SPX Algorithm 6 programs
Phantom Power Voltage +48 V
Power Supply Adaptor
PA-130 (DC12 V/1.0 A, Cable length = 1.8 m), 120 V, 60 Hz, or
MU18 (DC12 V/1.5 A, Cable length = 1.5 m), 100 V-240 V, 50 Hz/60 Hz,
or an equivalent recommended by Yamaha
Power Consumption 12 W
Dimensions (W×H×D) 149 mm×62 mm×202 mm
Net Weight 0.9 kg
Optional Accessory Mic Stand Adaptor: BMS-10A
Included Accessory
AC power adaptor, Owner’s Manual, Technical Specifications (this leaflet)
Operating Temperature 0 to +40°C
*1 Noise is measured with A-weighting filter. *2 Crosstalk is measured with 1 kHz band pass filter.
Analog Input Characteristics
Input Jacks
PAD
26 dB
GAIN
Trim
Actual
Load
Impedance
For Use
With
Nominal
Input level
Connector
Sensitivity *1 Nominal
Max. before
clip
MIC/LINE 1/L,2/R
OFF
+64 dB
3 kΩ
50-600 Ω
Mics/Lines
-72 dBu
(0 .195 mV )
-60 dBu
(0.775 mV)
-46 dBu
(3.884 mV)
Combo jack*2
(Balanced)
+20 dB
-28 dBu
(30.85 mV)
-16 dBu
(122.8 mV)
-2 dBu
(615.6 mV)
ON
+38 dB
-46 dBu
(3.884 mV)
-34 dBu
(15.46 mV)
-20 dBu
(77. 5 0 mV )
-6 dB
-2 dBu
(615.6 mV)
+10 dBu
(2.4 51 V)
+24 dBu
(12.28 V)
LINE 3/4, 5/6 - - 10 kΩ 600 Ω Lines
-22 dBu
(61.56 mV)
-10 dBu
(245.1 mV )
+4 dBu
(1.228 V)
Phone jack*3
(Unbalanced)
Analog Output Characteristics
Output Jacks
Actual Source
Impedance
For Use With
Nominal
Output level
Connector
Nominal Max. before clip
STEREO OUT L, R 75 Ω 10 kΩ Lines
+4 dBu
(1.228 V)
+18 dBu
(6 .156 V )
XLR-3-32 *4
Phone jack *5
(Balanced)
PHONES 33 Ω 40 Ω Lines 2.4 mW + 2.4 mW 24 mW + 24 mW Stereo phone jack
0dBu is referenced to 0.775Vrms.
*1 Sensitivity is the lowest level that will produce an output of +4 dBu (1.228 V) or the nominal output level when the unit is set to maximum gain. (All level knobs are at
their maximum position.)
*2 1&Sleeve = Ground, 2&Tip = Hot, 3&Ring = Cold
*3 Tip = Signal, Sleeve = Ground
*4 1 = Ground, 2 = Hot, 3 = Cold
*5 Tip = Hot, Ring = Cold, Sleeve = Ground
MIXING CONSOLE
Technical Specifications
VFU9230
See reverse side for block and level diagrams.
* The contents of this manual apply to the latest specifications as of the pub-
lishing date. To obtain the latest manual, access the Yamaha website then
download the manual file.
Dimensions
The illustration shows the MG06X.
149
2
30
62
56
202
28
201
Unit: mm
1