User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-41-
n Network Status
n Events
The use of each of these tabs is described in the next section.
Status Bar
The Status Bar displays notifications for network status, general device events, and clock status events,
plus the current Dante audio multicast bandwidth on the network.
DDMNetworks
In DDMnetworks, the devices displayed in the Network View will vary according to the selected domain.
See Viewing Domains in Dante Controller for more information.
When logged into a domain that includes legacy (pre-v4.0 firmware) devices, those devices are displayed
with gray highlighting instead of blue.
Shared devices are displayed with green highlighting and green text. See the DDMuser guide for more
information about sharing audio in DDM networks.
Status Bar
The Status Bar displays the following information:
n P: The current status of the Primary network. Green indicates that Dante Controller is currently con-
nected to the primary Dante network. Red indicates a problem with the connection.
n S: The current status of the Secondary Dante network. Only displayed where a secondary network is
connected.
n Multicast Bandwidth: The current Dante audio multicast bandwidth on the connected networks.
Note that there may be network traffic from other sources that is not included in the multicast band-
width reading.
n Event Log: Indicates the current status of the event log. Click the icon to open the Events View.
n Clock Status Monitor: Indicates the current status of the Clock Status Monitor. Click the icon to
open the Clock Status Monitor.