User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-63-
The label of the device being viewed is displayed in the middle of the toolbar. In the screenshot above,
FOH-Console is the device being displayed in the drop-down list box.
The device viewed can be changed by selecting another device from the drop-down list.
Multiple Device View windows may be opened from the Network View, so that several devices can be
examined simultaneously.
The Device View displays some or all of the following tabs, allowing you to see different information
relating to a specific Dante device:
n Receive: Display and configure device’s receive (Rx) channels
n Transmit: Display and configure device’s transmit (Tx) channels including multicast
n Status: Device software, clock and network status information
n Latency: View latency histograms (supported devices only)
n Device Config: Rename device, change sample rate and set other attributes (as relevant to device
type)
n Network Config:View and edit network configuration
n Issues: Displays information for devices in failsafe mode, or upgrade mode (upgrade mode is used
by ‘Ultimo’ low channel count devices only). Not usually visible.
n Baseboard: Only available when the Dante device is mounted on a Dante PDK audio baseboard
(NOTE: the device must be in SPI Master mode)
There are also dedicated configuration tabs displayed only for specific devices.