User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
135
19.
Assign a name to the input ports of the User Defined Block.
Enter the port names in the “Port Name” dialog box. To access the “Port Name” dialog box, click the port, and
then click the button located at the right of the [Label] editing area in the “Properties” area.
The output port names are automatically entered during a subsequent step.
20.
After you’ve entered the port names, click the [OK] button.
21.
Also enter a port name for the User Defined Block’s “IN.”
22.
Drag and drop to connect “IN” output ports 1 and 2 to “Fader(2)” input ports 3 and 4;
connect “IN” output port 3 to “Fader(2)” input port 1.
IN 1 BGM L
IN 2 BGM R
IN 3 Mic