User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
139
32.
Name the label of each User Defined Block so that it can be easily distinguished.
33.
Drag and drop to connect “Studio A” (Source Selector) output ports 1 and 2 to “Source
Mix Studio A” (User Defined Block) input ports 1 and 2; connect the “Input Ch Strip
(Studio A)” (User Defined Block) output port to “Source Mix Studio A” (User Defined
Block) input port 3.
Block Source Mix (Studio A)
Block(2) Source Mix (Studio B)
Block(3) Source Mix (Spin Area)