User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
198
Connecting the equipment
After you’ve rack-mounted the MRX and your other equipment, connect the MRX and the other equipment as shown
below. Insert the SD memory card into the MRX at this time.
WXC-50 (Studio A)
EXi8
Wireless Microphone Receiver
MRX7-D
PGM1
MCP1
SWR2100P-10G
XMV8280-D
Relaxation BGM Work out BGM2
Work out BGM1
WXC-50 (Spin Area)
WXC-50 (Studio B)
Spin Area Studio B Studio A
Weight Area
Pool
Cardio Area
Reception/Cafe
Child-mindings
Dress Rooms/
Rest Rooms
Spa