User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
201
Verifying that the settings were applied
The main items to verify are listed below. For details on each parameter’s settings, refer to “MTX-MRX Editor User’s
Guide” and “MRX Designer User’s Guide.”
1.
In “Output Ch.” User Defined Block, set “Speaker Processor” to a value appropriate for the
speaker.
2.
Input audio signals from the analog inputs and stereo inputs into the MRX7-D, and adjust
the input levels.
To check the input levels, you can use the “Fader” component editor and the “Fader” component editor within the
“Source Mix” User Defined Block.
3.
Adjust the EQ using the “PEQ” located inside the “Output Ch.” User Defined Block.
Since the Studio and Spin Area use mics, make adjustments while inputting sound to the mics.
4.
While inputting sound to the mic, adjust the parameters of the components in the “Input
Ch. Strip” User Defined Block.
5.
Operate the PGM1 to verify that paging broadcast occurs correctly.
6.
Operate the DCP and MCP1 units to verify that they work correctly.
When you have finished making all settings, save the project and switch MTX-MRX Editor offline.
This completes the settings for example 3.