User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
92
8.
Double-click “Fader(4).”
The “Fader(4)” component editor will appear.
9.
Move the fader in the Link Master editor, and confirm that the “Fader(4)” component editor
faders are linked together.
10.
Click the [×] button at the top right-hand corner of the “Fader(4)” component editor to
close the component editor.
Now open the Link Master editor, as we will be using it to register the Remote Control Setup List.
Repeat step 2 through 10 to create the following parameter link groups.
Now you’re finished setting the parameter link group.
Parameter link
group name
Components Parameters
Link Master editor
combo box settings
Mics On/Off [Fader(5)]
Ch01:On
Absolute
Ch02:On
Ch03:On
Ch04:On
Ch05:On
Ch06:On
Ch07:On
Ch08:On