User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
96
6.
Change the “File type” to “rcsl.”
The file extension will change to “rcsl.”
7.
Select the desired folder and change the file name as desired, and click the [Save] button.
The Remote Control Setup List used by ProVisionaire Touch will be saved.
8.
Click the [OK] button on the “Remote Control Setup List” dialog box.
The “Remote Control Setup List” dialog box is closed.
9.
Click the [×] buttons at the top right-hand corner of the Link Master editor and the compo-
nent editor to close the editor and component editor.
Now you’ve finished registering the Remote Control Setup List. Refer to the “ProVisionaire Touch Setup Guide” to learn
how to use ProVisionaire Touch.
The created file can be transmitted with “File Transfer” application. Refer to the “MRX Designer User Guide” for how to
use application.