User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
255
●If [FUNCTION] is [MTX ON]
Controls the on/off setting of the parameter.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch ON
•Fx RTN ON
• ZONE Out ON
•Output Ch ON
• Input Ch Mute Group
•ZONE Out Mute Group
❍ [DEVICE]
Select the device that you want to change.
❍ [PARAMETER1]
Specify the channel that will control the on/off setting of the parameter.
❍ [INPUT TYPE]
Specifies how the input voltage to GPI IN will be applied to the parameter.
You can choose [High Active], [Low Active], [Rising Edge], or [Falling Edge].
● If [FUNCTION] is [MTX Send Level] (Cannot be set for PORT8)
The input voltage to the [GPI IN] connector will control the send level of the channel.
If the maximum level cannot be reached because of the length of the cable, adjust the
maximum and minimum input voltage values in the “GPI Calibration” dialog box.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch Send Level
•Fx RTN Send Level
For details on these settings, refer to If [FUNCTION] is [MTX Level].
● If [FUNCTION] is [MTX Send ON]
The input voltage to the [GPI IN] connector will control the send on/off of the channel.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch Send ON
•Fx RTN Send ON
For details on these settings, refer to If [FUNCTION] is [MTX ON].
● If [FUNCTION] is [MTX Priority Ducker ON]
The input voltage to the [GPI IN] connector will turn the zone’s Ducker on/off.
Select one of the following parameter types, and then make the appropriate setting.
•1st Priority
•2nd Priority
For details on these settings, refer to If [FUNCTION] is [MTX Priority Ducker ON]
(switch only).