User Manual

Quick Guide
MTX5-D Owner’s Manual
19
Use MTX-MRX Editor to make adjustments for the entire sys-
tem.
1. Connect the computer to the MTX5-D/XMV/
EXi8/EXo8 via a network switch.
If you’re using only the MTX5-D, you can connect it
directly to the computer.
2. Start up MTX-MRX Editor and load the proj-
ect file that you previously created.
3. Power-on the MTX5-D.
4. Power-on the XMV/EXi8/EXo8 and the analog
input amps.
5. In the [To Device] direction, place the MTX5-
D/XMV/EXi8/EXo8 and MTX-MRX Editor
online (in a synchronized state).
“Online” refers to the state in which the MTX5-D itself is
connected with MTX-MRX Editor and is synchronized.
When the devices are online, MTX-MRX Editor can be
used to control the MTX5-D/XMV/EXi8/EXo8. For details
on how to put the device online, refer to “MTX-MRX Edi-
tor User Guide.”
6. Check the presets.
Recall a preset, and verify that the settings are correct.
For details on presets and how to recall them, refer to
“Recalling (switching) presets” on page 20.
7. Check the signal processing.
Input audio signals into the MTX5-D, and check the meters
in MTX-MRX Editor to verify that the volume and routing
are set correctly.
8. Adjust the output level of the MTX5-D and the
output level of the amps so that the audio is
output from the speakers at an appropriate
level.
One by one, turn on each output channel and adjust its out-
put level.
9. Store the preset.
Recall, edit, and save other presets in the same way.
10. Save your settings and close MTX-MRX Edi-
tor.
A project file with the extension “.mtx” will be created.
On-site work (Settings in MTX-MRX
Editor)
NOTE
The settings you make while online are saved in the
MTX5-D itself, but we recommend that you use MTX-MRX
Editor to save them as a project file for future maintenance
and readjustments.