User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Device Information” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
166
❑ “Device Information” dialog box
Lists the devices on the network, allowing you to update their firmware and change their IP address.
● Network Interface
Shows the name/IP address/subnet mask of the network card currently selected in the
“Select Network Interface Card” dialog box.
● Device list
• Identify button
When you press this button located at the left of the UNIT ID, the indicators of the
corresponding device will flash for five seconds.
•Unit ID
Shows the UNIT ID of the device.
If there is a UNIT ID conflict, this is indicated as follows.
•Type
Shows the model name of the device (except for digital control panels).
• Device Name
Shows the device name. This name can be edited in DEVICE NAME, which is
located in the [Device] tab at the bottom of the Project screen.
• IP Address/MAC Address
Shows the IP address and MAC address that are specified for the device.
•Serial No.
Shows the serial number of the device.
•Version
Shows the firmware version.
• Status
Shows the online or offline status.
When updating a device, the progress is shown.