User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“MCP1” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
211
● [Dimmer & Lock] tab
Here you can make settings for the brightness of the MCP1’s display and switches, and
for panel lock.
• [Brightness] check box
If this check box is selected, the brightness and contrast of the display, and the
brightness of the switches, can be changed when a preset recalls the currently-edited
library item.
[LCD Brightness] specifies the brightness of the display. Higher values will make the
display brighter.
[LCD Contrast] specifies the display’s contrast. Higher values produce a greater
difference between light and dark.
[LED Brightness] specifies the brightness of the switches. Higher values will make
the switches brighter.
If the check box is cleared, the drop-down menu is grayed out and you will be unable
to set the brightness.
• [Panel Lock] check box
If this check box is selected, the MCP1 panel will be locked when the library item is
recalled by a preset.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding
down the MCP1’s home switch for two seconds or longer will unlock the panel.
If the [Enter PIN to unlock MCP1] check box is selected, pressing and holding down
the MCP1’s home switch for two seconds or longer will then require the PIN code
specified in [Panel Unlock PIN:] of the “PIN CODE” dialog box to be entered on the
MCP1.
•[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the
panel is locked.