User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Get Log” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
231
❑ “Get Log” dialog box
A record of the MTX/MRX system’s operation is stored as a “log” in the MTX/MRX’s internal
memory. In this dialog box you can output the logs of all MTX/MRX units existing on the subnet
to which your computer is connected, and save them as a file. The log file is in “.csv” format.
• The Project screen’s [Alert] tab does not show the information listed in the alert list, but this
is captured in the log.
• The MCP1 and PGM1/PGX1 are not subject to capture in the log.
● [Output File Name] box
Shows the location (absolute path) in which the log file is saved. You can also enter this
directly.
● Browse button
Opens the file browser and selects the file that will be output as the log.
● [Log Clear] button
Deletes the log for all MTX/MRX units existing on the subnet.
When you click this button, a confirmation message will appear. If you click the [Yes]
button, the log will be deleted. If you click the [No] button, the operation will be
cancelled and the dialog box will close. You may be asked to enter the PIN code.
● [OK] button
Outputs the log file and closes the dialog box.
● [Cancel] button
Cancels log file output and closes the dialog box.
NOTE
Browse button