User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Alert list Appendix
MTX-MRX Editor User Guide
273
202
The firmware update has been
completed.
–
Information Single
203
Initialization has been
executed.
–
Information Single
204
Panel lock has been disabled.
–
Information Single
205
The IP address has been
established.
–
Information Single
206
The network IP address has
been allocated from the DHCP
server.
–
Information Single
207
The network IP address has
been released by the DHCP
server.
–
Information Single
208
An EMG (Emergency) signal
was received, and the device
switched to EMG mode.
–
Information Continuing
209
The setting of the internal clock
has been changed.
–
Information Single
210
The event has been executed
using the scheduler.
–
Information Single
211
MTX-MRX Editor began
synchronisation.
–
Information Single
213
A login failure has occurred
from an external remote
controller via the remote control
protocol.
–
Information Single
214
A login authentication has been
successfully completed from an
external remote controller via
the remote control protocol.
–
Information Single
215
The SD memory card has been
mounted properly.
–
Information Single
216
The SD memory card was
removed while the MTX was
turned on.
–
Information Single
217
Preset number ** was recalled.
–
Information Single
218
Preset number ** was stored.
–
Information Single
220
The clock has been
successfully synchronized by
the time server.
–
Information Single
221
Preset number ** was edited.
–
Information Single
222
A snapshot/snapshot group
was recalled.
–
Information Single
223
Snapshot was stored.
–
Information Single
224
Snapshot was edited.
–
Information Single
225
Snapshot group was edited.
–
Information Single
Number Content Action Type
Single/
Continuing