User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
If [FUNCTION] is [MRX Parameter]
MRX Designer User Guide
133
■ If the parameter registered to a switch is an Level-type
parameter (DCP)
● If the [Control Type] is [Inc/Dec]
Use the switch to change the level or send level.
❍ [Inc]
If you select this option, pressing the switch each time will raise the level or the send
level.
✦[Upper Limit]
Specifies the maximum level achieved when you press the switch.
✦[Minimum]
If the current parameter value is lower than the value specified here, pressing the
switch once will set the parameter to this value.
❍ [Dec]
If you select this option, pressing the switch each time will lower the level or the send
level.
✦[Lower Limit]
Specifies the minimum level achieved when you press the switch.
✦[Mute Enable] check box
If this is on, the Mute state (–∞ dB) will be enabled if the level is lowered below
the value specified by [Lower Limit].
❍ [Switch]
Allows you to make switch-related settings.
[Sensitivity] specifies the sensitivity at which the parameter will change when the
switch is pressed.