User Manual

Wire
MRX Designer User Guide
145
❑ Wire
The following context menu appears when you right-click a wire.
❑ Design sheet
The following context menu appears when you right-click a design sheet that contains no
components.
❑ “Parameter Sets” area
The following context menu appears when you right-click a parameter set, device, component, or
parameter in the “Parameter Sets” area.
Menu Content
Delete Deletes the wire.
Bring to Front Moves the selected wire to the front.
Send to Back Moves the selected wire to the back.
Add a Transmitter &
Receiver
Connects the selected wire using a Transmitter component and Receiver
component.
Menu Content
Paste Pastes the copied component to the design sheet.
Select All Selects all components and wires in the design sheet.
Select All Wires
Selects all wires in the design sheet.
(Except for those inside a User Defined Block)
Close All Editor
Windows
Closes all component editor and parameter setting windows.
Snap To Grid If this is checked, components are aligned with the grid of the design sheet.
Menu Content
Find
If you execute this for a component, the corresponding component in the design
sheet is selected.
If you execute this for a parameter, the component editor that includes the
corresponding parameter will open with that parameter selected.
This cannot be executed for a parameter set or device.
Delete Deletes the item. Settings in a lower level are also deleted.