User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Design sheet
MRX Designer User Guide
20
Design sheet
Here you can place components and connect them.
Parameter settings are the main operations that you can perform while online. Operations such as
placing and connecting components can only be done while offline.
❑ Placing components
Here we explain how to place components on the design sheet.
If any component in the “Components” area is selected, pressing an alphabetical key will
select the component of the matching initial letter.
• Placing a single component
Drag a component from the list in the “Components” area and drop it on the design
sheet.
• Placing multiple instances of the same component
Double-click on a component in the “Components” area to select Stamp mode; in
this mode, the component is placed each time you click the design sheet. To cancel
Stamp mode, press <Esc> or click any component in the list.
• Changing the number of channels for a component you placed
In the “Properties” area, click the property Form field; then click the [...] that appears
and select the desired number of channels. This cannot be changed on a component
for which [...] is not shown.
NOTE