User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 5 Main panel window
Amp Editor Owner’s Manual
83
[GPI] tab (ACD1 only)
Calibrates the input voltage detection range for the device’s [GPI] connector.
[All Ports] check box
Selects the check boxes of all ports.
Port check boxes
Specifies the selected ports as the target of calibration.
Calibration data
Indicates the input voltage in realtime.
[Reset] button
Resets the calibration of the selected port(s).
[Max] button
Sets the current input voltage of the selected port(s) as the maximum value. The specified maximum value is
shown as a red marker.
[Min] button
Sets the current input voltage of the selected port(s) as the minimum value. The specified minimum value is
shown as a blue marker.
Port check boxes
Setting the maximum
input voltage
Setting the minimum input voltage Calibration data