User Manual

10
PX10/PX8/PX5/PX3 Reference Manual
Setup
1. Set the PX amplifier in the desired loca-
tion.
If the device is to be mounted in a rack, refer to “Rack
mounting” (page 11).
2. Lower the two volume knobs to the mini-
mum.
3. Connect speakers to the [SPEAKERS]
terminals.
Refer to “Speaker connection” (page 11).
4. Connect outputs from sources, such as
a mixer, to the [INPUT] connectors.
5. Connect the power cord to the [AC IN]
connector.
Secure the AC power cord with the AC plug clamp to
prevent accidental disconnection from the connector.
6. Turn on the device.
7. Set up the system configuration with the
Configuration Wizard.
Though the PX amplifier can be used as a normal ampli-
fier by simply setting the volume knobs properly, using
the Configuration Wizard to make settings enhances the
performance of speakers.
Refer to “CONFIG WIZARD screen (Basic mode)”
(page 20) or “CONFIG WIZARD screen (Advanced
mode)” (page 22).
8. Rotate the volume knob to adjust the vol-
ume.
9. Control the tone in TUNING screen.
Refer to “TUNING screen” (page 25). In this condition,
the device is available.
Setup procedure
WARNING
To ensure that high-volume noise is not output from the
speakers, power-on the equipment starting with the
audio sources, then the mixer and processors, and
finally the amplifiers. Reverse this order when turning
the system off.
To A C p o w e r
outlet
Power cord
AC IN connector
Installing the AC plug clamp
qwe