User Manual

Panel Operation — MENU screen
18
PX10/PX8/PX5/PX3 Reference Manual
 Operation tree
Category Subcategory Function
Basic
mode
Advanced
mode
Details
CONFIG WIZARD
(Basic mode)
SP TYPE Selects a combination of speakers for connection.  page 20
SP SERIES Selects a series of speakers for connection.  page 20
SP MODEL Selects a speaker for connection.  page 20
HPF Selects the cutoff frequency of the HPF. Common to channels A and B.  page 21
LPF Selects a cutoff frequency of the LPF. Common to channels A and B.  page 21
X-OVER Selects a crossover frequency of the full-range speaker and the subwoofer.  page 21
CONFIRMATION Applies the set value.  page 21
CONFIG WIZARD
(Advanced mode)
WIZARD MODE Selects the editing method: changing the current setting or making a new setting.  page 22
SP TYPE Selects a combination of speakers for connection.  page 22
ROUTING Selects the route of the input signal.  page 23
SENS./GAIN Sets the input sensitivity or the amplifier gain.  page 24
SP SERIES Selects a series of speakers for connection.  page 24
SP MODEL Selects a speaker for connection.  page 24
SP IMPEDANCE Sets the impedance of the speaker for connection.  page 24
CONFIRMATION Applies the set value.  page 24
TUNING
D-CONTOUR Sets the frequency character appropriately for usage of the speaker for connection. page 25
DELAY Sets the delay time to compensate the distance between speakers.  page 26
X-OVER Sets the crossover frequency. page 26
HPF Sets the high pass filter. *  page 27
LPF Sets the low pass filter *  page 27
POLARITY Set the polarity. page 28
SP DELAY Sets the delay time of the speaker processor.  page 28
EQ Edits 6 Band PEQ settings.  page 29
LEVEL Sets the output level.  page 29
LIMITER Sets the limiter.  page 30
CHANNEL LINK Links the parameter setting of channels A and B.  page 30
CHANNEL COPY Copies settings between channels.  page 30
SAVE/LOAD Saves or loads SP TUNING DATA via a USB flash drive.  page 31
* Only for some functions.