User Manual

Panel Operation — CONFIG WIZARD screen (Basic mode)
21
PX10/PX8/PX5/PX3 Reference Manual
 HPF (high pass filter)
(If “SP SERIES” is “GENERIC”)
Selects the cutoff frequency of the HPF. Common to both channels A and B.
 LPF (low pass filter)
(If “AMP MODE” is “SUB+SUB” and “SP SERIES” is “GENERIC”)
Selects the cutoff frequency of the LPF. Common to both channels A and B.
 X-OVER (crossover)
(If “AMP MODE” is “FULL+SUB” and “SP SERIES” is “GENERIC”)
Selects the crossover frequency of the full-range speaker and subwoofer.
 CONFIRMATION
Applies the set value.
After confirming the setting is appropriate, press the main knob to actually apply the set
value.
To correct the setting, press the [ ] (back) key to return to the screen to be corrected.
To cancel the setting, press the [MENU] key or press and hold the [ ] (back) key until a
confirmation screen appears.
NOTE
In Basic mode, the filter type is fixed to 24 dB/Oct., Butterworth type.
NOTE
In Basic mode, the filter type is fixed to 24 dB/Oct., Butterworth type.
NOTE
In Basic mode, the filter type is fixed to 24 dB/Oct., Linkwitz Riley type.