User Manual

Panel Operation — CONFIG WIZARD screen (Advanced mode)
24
PX10/PX8/PX5/PX3 Reference Manual
 SENS./GAIN (input sensitivity/amplifier gain)
Sets the input sensitivity or the amplifier gain.
You can select the input sensitivity(+4 dBu or +14 dBu), or the amplifier gain (26 dB or 32
dB).
 SP SERIES (speaker series)
Selects a speaker series for connection from models registered in the PX amplifier.
 SP MODEL (speaker model)
Specifies a speaker for connection from the speaker series selected in SP SERIES screen.
 SP IMPEDANCE (speaker impedance)
(If “SP SERIES” is “GENERIC”)
Sets the impedance of the speaker for connection.
When connecting speakers in parallel, set this parameter by a single speaker's impedance.
 CONFIRMATION
Applies the set value.
After confirming the setting is appropriate, press the main knob to actually apply the set
value.
To change or correct the setting, press the [ ] (back) key to return to the previous screen.
To cancel the setting, press the [MENU] key or press and hold the [ ] (back) key until a
confirmation screen appears.
NOTE
Refer to “Input sensitivity and amplifier gain” (page 7) for details on input sensitivity and amplifier
gain.
NOTE
When a speaker is selected, filters, speaker impedance, and threshold of the limiter are set auto-
matically. If the speaker for connection is not in the menu, select “GENERIC.”