User Manual

Panel Operation — AMP PRESET screen
32
PX10/PX8/PX5/PX3 Reference Manual
PX amplifier settings that are set in CONFIG WIZARD screen and D-CONTOUR screen can
be stored as amplifier preset. Eight amplifier presets can be stored in a PX amplifier.
Select the number of the desired amplifier preset by rotating the main knob and pressing it.
The operation selection screen appears.
 RECALL
Recalls a stored amplifier preset. The current speaker preset and the speaker preset of the
selected amplifier preset appear.
 STORE
Stores the current PX amplifier setting to an amplifier preset, and allows you to name it.
Rotate the main knob to select the position to input the character and press the main knob
to switch to character entry. Then rotate the main knob to select the character to be input
and press the main knob to actually enter it.
By pressing the [ ] (back) key in the character entry mode, you can return to selecting
the position. Selecting “OK” in this state confirms the title.
 CLEAR
Clears a stored amplifier preset.
AMP PRESET screen
WARNING
If a speaker type different from the current one is recalled, the volume will change signifi-
cantly. Carry this out with the volume lowered for safety.
NOTE
The PX10/PX8 cannot recall an amplifier preset stored on the PX5/PX3 in the Power Boost mode.
Protected amplifier
preset
Currently selected
amplifier preset
Current speaker type
Speaker type of selected
amplifier preset
NOTE
A protected amplifier preset cannot be overwritten.
NOTE
A protected amplifier preset or the currently selected amplifier preset cannot be cleared.
Cursor when selecting
the position
Cursor when selecting
the character