User Manual

Reference — Message list
43
PX10/PX8/PX5/PX3 Reference Manual
55 USB:I/O ERROR Cannot read/write the USB flash drive properly.
Confirm that the USB flash drive you are using works properly with a computer. Use
a tested USB flash drive. Refer to Yamaha Pro Audio global website (http://
www.yamahaproaudio.com/) for tested USB flash drive. Should this also fail, con-
tact your Yamaha dealer.
56 USB:STORAGE FULL! The remaining capacity of the USB flash drive is not sufficient. Make sure the USB flash drive has enough free space.
58 USB:LOAD ERROR
The USB flash drive has been unplugged during access. A failure
has occurred in reading files from the USB flash drive. Data in the
PX amplifier may be corrupted or lost.
Try again. The [USB] indicator flashes when the USB flash drive is being accessed.
Do not unplug the USB flash drive during this time.
65 INCOMPATIBLE DATA LOADED
The recalled preset includes incompatible settings, so the setting
has reverted to the default. This also results when a file stored
from PX5/PX3 in Power Boost mode has been restored.
—
70 POWER TURNED ON The device has been turned on. —
71 POWER TURNED OFF The device has been turned off. —
72 SHORT INTERRUPTION
An instantaneous power failure occurred, causing the device to
shut down and start up again.
Connect to a stable power supply.
73 FIRMWARE UPDATE COMPLETED Completed the update of the firmware. —
74 PANEL UNLOCKED Released the panel lock. —
75 SP PRESET RECALLED[*] Recalled a speaker preset. (*: speaker preset number) —
76 SP PRESET LOADED Loaded a speaker preset from the USB flash drive. —
77 AMP PRESET RECALLED[*] Recalled an amplifier preset. (*: amplifier preset number) —
78 AMP PRESET STORED[*] Stored an amplifier preset. (*: amplifier preset number) —
79 AMP PRESET CLEARED[*] Cleared an amplifier preset. (*: amplifier preset number) —
80 BACKUP DATA LOADED
Loaded setting data from a USB flash drive with “RESTORE
FROM USB” in DEVICE BACKUP screen.
—
90 CONFIG+TUNING DATA INITIALIZED Initialized the configuration and tuning data. —
91 ALL DATA INITIALIZED Initialized all the parameter settings. —
92 FACTORY DATA RESET Initialized all the speaker presets and parameter settings. —
Number Message Symptom Possible solution