User Manual

15.3. Editor
Double clicking the EXi8 on the Project sheet will open the [EXi8] editor.
•
[+48V] button
Switches the HA phantom power supply (+48 V) ON and OFF.
NOTE
If the phantom power supply is not required, turn this button OFF.
If the phantom power supply is turned ON, please note the following to prevent damage or noise to the
main unit/external devices.
• When connecting a device that is not phantom power compatible to an [INPUT] terminal, turn the button
OFF.
•Do not disconnect cables from the [INPUT] terminal while the power button is still ON.
•Set the output level to its lowest level when turning the phantom power supply off or on.
There is no ACTIVE switch. Use settings that match the connected equipment to avoid damage.
•
HA analog gain
Adjusts the HA (headphone amp) analog gain.
•
[HPF] button/cutoff frequency
Switches the HPF (high-pass filter) ON and OFF.
Sets the HPF cutoff frequency.
•
[φ] button
Switches the input signal phase.
•
[ON] button
Switches the input channel ON and OFF.
•
YDIF Out
Select the channel to output to YDIF.
If you select Thru, the signal that is input from YDIF In will be output as-is.
15. MTX I/O Expanders : EXi8 / Exo8
242 | ProVisionaire Design User Guide