User Manual

To specify the Dante patching, make settings in Dante Controller.
◦ [Active Redundant Mode] check box
If this check box is selected, the redundancy function is enabled.
The [Redundant Mode] list box determines the redundancy mode. If [Off] is selected, the
redundancy function is disabled even if this check box is selected.
◦ [Analog] option button
The signal is taken from the analog input jack of the corresponding channel.
•
"Redundant Mode - Backup" area
Here you can specify how the pilot tone is detected for each channel.
◦ [Frequency] spin box
Specifies the center frequency of the pilot tone.
◦ [Detection Threshold] spin box
Specifies the input level threshold value for the pilot tone. Input that exceeds the threshold value is
considered to be the pilot tone.
▪ [Detection Time] spin box
Specifies the detection time for the pilot tone. If the pilot tone can not be detected for the
specified time interval, it is determined that the input has ceased.
▪ [Notch Filter] check box
If this check box is selected, a notch filter is enabled to eliminate the frequency component
of the pilot tone so that the pilot tone is not output from the amp.
◦ [Q] spin box
Specifies the width of the frequency band for the notch filter.
•
"Redundant Mode - Override" area
Here you can specify the conditions under which each channel will switch to the analog input in Override
mode.
◦ [Override Threshold] spin box
Specifies the threshold value for the analog input. When the threshold value is exceeded, the input
source will switch to analog.
◦ [Auto Return Delay] spin box
If the [Auto Return] check box is selected, this specifies the time after the analog input falls below
the threshold value until the input is switched back to the digital input.
•
[Save Changes] button
Saves the settings and closes the dialog box.
•
[Cancel] button
Discards the changes and closes the dialog box.
17. Power Amplifiers : XMV-series
ProVisionaire Design User Guide | 273