User Manual

[INPUT ADJUST] Knob
Adjusts the input gain. However, the output gain changes in the opposite direction so that the
passing volume (volume when [COMP IN] and [LIMIT IN] are off) does not change. For example,
when [INPUT ADJUST] is +5 dB, the input gain is +5 dB and the output gain is -5 dB.
How INPUT ADJUST Works
Since the threshold changes substantially, the displayed value changes in tandem. However, the
internal state of the COMPRESSOR/LIMITER SECTION does not change.
[LINK] Switch (in stereo mode)
Activates/Deactivates the stereo link.
COMP [IN] Switch
Activates/Deactivates the compressor.
COMP [THRESHOLD] Knob
Sets the threshold for the compressor. However, the value changes in conjunction with [INPUT
ADJUST].
COMP [RECOVERY] Knob
Sets the release time of the compressor. The release time of a1 (auto 1) and a2 (auto 2) changes
automatically.
a1: Changes automatically between 100 ms and 2 sec.
a2: Changes automatically between 50 ms and 5 sec.
COMP [GAIN] Knob
Sets the make-up gain of the compressor. It works in front of the limiter.
COMP [RATIO] Knob
Adjust the ratio of the compressor.
[METER] Select Switch (in stereo mode)
Selects the signal source for the meters. You can select from three options: IN (input level), GR
(gain reduction), and OUT (output level). When you switch the signal source, the meter design
(VU/GR/VU) also changes.
Dynamics Plug-ins
66 | VST Rack Pro Plug-in Reference