User Manual

Screen areas
User's Guide
TF StageMix
- 21 -
4 Meter display
Displays the post-fader channel level.
Two meters are displayed for MONITOR channels and for channels linked as a stereo pair.
Meters are not displayed for DCA channels.
5 Fader value
Displays the value of the current fader level. You can tap the value and then increase and decrease it by tapping the up and
down arrows.
CH Name area
Allows you to adjust the channel's pan/balance, and displays the channel's number, name, icon, and color.
1 Pan/balance slider
Drag left and right to adjust the pan or balance of the channel.
The control stops at the center position; you can then continue to drag it left or right as desired.
When the pan or balance is set to the center position, a round icon is displayed. You can also double-tap this area to set the
pan or balance to the center position.
You can adjust pan/balance for multiple channels at the same time.
2 Channel display
Displays the channel number, name, icon, and color.
Overview strip area
The STEREO channel strip is normally displayed in the overview strip area. When using SENDS ON FADER mode, the destination
AUX channel, SUB channel, or MATRIX channel strip is displayed here.
You can switch to SENDS ON FADER mode by tapping a channel number displayed on the left side of the strip. The selected channel
will be highlighted in the channel's color. Tapping on Exit at the bottom or the selected channel number restores the regular mode.
NOTE
• If you have adjusted the Fader/Pan Delay setting on the PREFERENCE screen (page 16), the fader value is displayed in light blue when
the fader can be adjusted.
• If Fader 0dB Detent on the PREFERENCE screen is turned off (page 16), the value fader does not stop at the nominal point.
ձ
ղ