User Manual

Screen areas
User's Guide
TF StageMix
- 27 -
INPUT screen
Displayed when you tap the INPUT button in the TOOLBAR area.
Allows you to turn phantom power on and off, toggle the signal phase, and adjust input gain.
1 Stereo link selection button
Allows you to select whether two adjacent mono input channels are linked as a stereo pair, or behave as two separate mono
channels. Tap to display the popup menu.
OFF: Stereo link is disabled.
CH1&2: Stereo link is enabled. When stereo link is enabled, the odd numbered channel is the left side of the stereo pair, and
the even numbered one is the right. The channel numbers displayed in the popup menu depend on the channel
whose settings you are editing.
CH2&3: Stereo link is enabled. When stereo link is enabled, the even numbered channel is the left side of the stereo pair, and
the odd numbered one is the right. The channel numbers displayed in the popup menu depend on the channel
whose settings you are editing.
2 Input selection
Allows you to select the input source selected on console.
3 GainFinder
Displays the input gain level. When adjusting the input gain, adjust it so that the center of the GainFinder lights up. When
USB is selected as the console's input, the input's digital gain is displayed here.
VIRTUAL will be displayed when there are no I/O devices connected and SLOT is selected as the console's input.
4 +48V button
Turns phantom power (+48V) to the head amp on and off.
On: Phantom power is turned on.
Off: Phantom power is turned off.
When USB is selected as the console's input, this button is not displayed.
This button is disabled when "Enable Phantom Power Switching" on the PREFERENCE screen of the SETUP screen is disabled. (  page 16 )
5 Φ (phase) button
Allows you to reverse the input signal phase. When turned on, the input signal's phase is reversed.
6 Gain sliders
When INPUT is selected as the console's input, the slider adjusts the analog gain of the head amp.
The PAD (-24dB) will be switched on or off when the analog gain is adjusted between +17dB and +18dB.
When USB is selected as the console's input, the slider adjusts digital gain.
NOTE
When SLOT is selected as the console's input, analog gain adjustment and the +48V button cannot be used if the HA Control button on the
SLOT SETUP screen is not turned on. Additionally, for inputs from a device whose head amp cannot be controlled, the gain slider
6 becomes
a digital gain adjustment, and the +48V button
4 is not displayed.
նմյո
չձ ղճշ